Editing Sensor Labels - Omntec OEL8000II Installation Manual

2. Enter the location using the keypad.
3. Select ENTER.
If your system includes a temperature sensor (BX-TC-1), vapor sensor (BX-VS),
or humidity sensor, you must program them. Complete labeling all system
sensors then proceed to the appropriate section below for programming
instructions. Contact the manufacturer if your system includes a humidity
sensor.
4.3.5.1.3
When you select OK in the Config – Search Results Screen (see Step 1 in Section
4.3.5.1.1 – Sensor Labeling), the Label Screen (see Figure 4-9e) is displayed
prompting you to select a label. If a sensor had already been labeled during previous
programming, the Label Edit Screen (see Figure 4-9h) will be displayed instead
allowing you to make edits.
To edit a previously labeled sensor, do the following:
1. Starting in the Sensor Submenu (see Figure 4-8a), select CONFIG.
2. After the system has completed searching for sensors, select OK in the Config. –
Installation Manual
TU 02/06/07
01: BXLS S/N: 000064787
Location:
ENTER
System Response
The location will appear on line 3.
System Response
The Label Screen (see Figure 4-9e) will be displayed for the next
sensor.
Line 1 remains unchanged.
Line 2 displays the sensor number, type, and serial number.
Line 3 displays: Need Location Label...
Line 4 displays the appropriate labels for the sensor (see Table
4-1).

Editing Sensor Labels

Search Results Screen (see Figure 4-9d).
15:24:31 *STATUS:SETUP
|ERASE ALL |
Fig. 4-9g: Other Label Screen
Important!
OEL8000II
|EXIT
4-35