Programming; Preparation - Omntec OEL8000II Installation Manual

Section 4
4.1

Preparation

Most systems are factory programmed. If your system is pre-programmed verify that
all settings are accurate to your site needs.
This section describes the programming of the controller. It is the final step in the
installation process and it is performed after all of the hardware has been installed
and all of the electrical connections have been made. To complete this procedure, you
will need tank data, probe and sensor data, and additional data to be obtained from
the customer. Before you begin programming, it is recommended that you review this
section and obtain all of the required information. You may use this part of the
manual as a worksheet by recording all of the data in the appropriate sections.
Installation Manual

Programming

Mounting
Holes
LEDs
Printer
Cover
Feeder
Button
Paper
Slot
Mounting
Holes
Fig. 4-1: OEL8000II Controller's Front Panel
OEL8000II
LCD
Arrow
Keys
Function
Keys
Lock
Data
Keypad
4-1