Unpacking, Inspection And Damage Claims - Omntec OEL8000II Installation Manual

Overview
♦ Do not perform any installation or service procedures if you are not qualified to
work with intrinsically-safe systems.
♦ Do not perform any installation or service procedures if you are not familiar with
the National Electrical Code and all other federal, state, and local codes and
regulations pertaining to this installation.
♦ Do not perform any installation or service procedures until you have read through
and understand this entire manual.
♦ Do not install the controller in a hazardous location.
♦ Do not drill through enclosure
♦ Do not mount outdoors without ENC-4X weather proof enclosure
♦ Do not install RAS series remote Annunciators in hazardous locations.
♦ Only sensors and probes are to be installed within hazardous locations.
♦ Do not substitute components. The intrinsic safety design can become
compromised creating an explosion hazard. It will also void the warranty.
♦ Do not apply power to the controller until all of the other installations and wiring
have been completed and inspected. Read Section 3 – Applying Power. Applying
power to the controller and programming the controller are the final steps in the
installation process.
♦ Always remove power to the controller before servicing.
♦ Take all safety precautions to avoid accidents.
♦ Keep work area clean.
♦ Block off work area when working on tanks and hazardous locations to prevent
vehicles and pedestrians from entering the area.
♦ Use proper fire prevention measures to keep all sparks, flames, and other ignition
devices away from the hazardous area.
1.3

Unpacking, Inspection and Damage Claims

Unpack and thoroughly inspect all equipment before accepting receipt from carrier. If
you detect or suspect any damage or loss, do the following:
♦ Write a detailed description of the damage or loss on the front of the bill of lading
and sign it.
♦ Have the carrier's agent sign the bill of lading.
♦ Immediately notify the carrier by phone and follow up in writing within 48 hours.
The buyer assumes all risk for damage or loss of merchandise incurred during
shipping and is responsible for filing and settling any claims. If you report your loss
to OMNTEC
1-2
®
Mfg., Inc. however, we will attempt to assist you with your claim.
®
OMNTEC Mfg., Inc.