Remote Horn Time Enable/Disable - Omntec OEL8000II Installation Manual

Programming
Note: This does not affect the controller's horn, which can only be shutoff by
pressing the ACK key on the controller's panel or correcting the alarm condition.
1. To keep the current value, skip to Step 3. To change the value, press the
2. Enter the time-out value in minutes (maximum of 4 numerical characters).
3. Select ENTER.
4.3.8.3
This permits you to enable or disable the Remote Horn Timeout discussed in the
previous section. If you select disable, the annunciator's horn will not time-out. In the
event of a high product alarm, the horn will sound until the annunciator's reset button
has been pressed, the controller's ACK key has been pressed, or the alarm condition
has been corrected.
1. To keep the current value, skip to Step 3. To change the value, press the
2. Enter E for enable or D for disable.
3. Select ENTER.
4-50
DELETE key as often as necessary to erase the old number.
Note: If no value has been previously programmed, Line 3 will be blank.
System Response
Line 3 will become blank and show a cursor.
System Response
The time-out value will appear on line 3.
System Response
Lines 1 and 4 of Figure 4-13 remain unchanged.
Line 2 displays: Set remote horn time enable, E/D.
Line 3 displays the default value (E) or the currently
programmed value.

Remote Horn Time Enable/Disable

DELETE key as often as necessary to erase the old number.
System Response
Line 3 will become blank and show a cursor.
Note: If any character other than E is entered, the system will automatically
program the default value D.
System Response
The character you entered will appear on line 3.
®
OMNTEC Mfg., Inc.