Table of Contents
Advertisement
OptiTap Installation
!
CAUTION
Ensure that fiber used is UL Listed Optical Fiber Cable suitable for this
application, and does not contain any metallic members or other electrical
conductive materials.
To install the OptiTap Connector to the ONT, refer to
and complete the following steps:
1. Unscrew the Jam Nut and remove it and the Plastic Washer from the end of OptiTap
2. Slide the Fiber Optics Connector through the Mounting Bracket.
3. Position the Mounting Bracket in the groves in the NID Housing (refer to
4. Replace and tighten the Plastic Washer and Jam Nut.
61287703G1-5B
Cable Connector.
page 2-12).
Jam Nut
Plastic
Washer
Section 2, Installation and Testing - Fiber Installation
Figure 2-5. OptiTap Installation
Figure 2-5
and
Figure 2-6
Mounting
Bracket
OptiTap Cable
Connector
Fiber Optics
Sleeve
Fiber Optics
Cable
on page 2-12
Figure 2-6
on
2-11
Advertisement
Table of Contents
Troubleshooting
