Overview; Fixture - ETC fos/4 Series User Manual

Overview

Fixture

B
C
D
Accessory holder: Insert accessories into the two available slots from either side of the holder,
A
and then lock the holder. See
Cable tie: Store power cable on the yoke.
B
Yoke tilt-lock: Tilt the fixture as needed, and then turn the tilt-lock clockwise to lock the
C
position. If necessary, pull the tilt-lock away from the stem to adjust the tilt-lock position.
Adjustable yoke: Loosen the bolts, and then shift the adjustable yoke forward or backward as
D
needed to balance the fixture. Tighten the bolts to secure. See
Zoom knob: Rotate the zoom knob on either side of the fixture to adjust from spot to flood.
E
NFC (Near Field Communication) tag: Use the Set Light app to wirelessly configure the fixture,
F
with or without power applied to the fixture. See
User interface: View the fixture status, set the DMX address and mode, or set stand-alone
G
options.
Antenna: For use when controlling the fixture using wireless DMX. See
H
.
on page 18
Safety cable attachment point: See
I
DMX In and DMX Thru connectors: Five-pin XLR connectors for DMX/RDM in and thru.
J
Power In and Power Thru connectors: powerCON
K
thru.
Battery connector: Three-pin XLR connector for battery power. Connect the fixture to battery
L
power only when AC power is not available. Maximum fixture output may be reduced when
powered by battery.
Overview
A
A
E
Add Accessories on page 7
Set Up Wireless Control on page 18
Mount the Fixture on page 7
®
I
J
K
.
Add Accessories on page 7
Set Up Wireless Control
.
TRUE1 TOP connectors for power in and
H
G
F
E
L
.
.
5