Set Up And Focus The Fixture; Mount The Fixture; Add Accessories - ETC fos/4 Series User Manual

Set Up and Focus the Fixture

WARNING:
Only use mounting hardware that is rated for the total weight of the
•
fixture and accessories.
In addition to primary suspension, attach a safety cable (or other
•
approved safety device) to the fixture. Safety cables must be rated to
support ten times the fixture weight. Consult local standards to ensure
that safety cables meet all requirements. See
Check that the accessory holder is locked and that any accessory safety
•
cables are connected before mounting the fixture.
AVERTISSEMENT :
suivants avant toute utilisation :
N'utilisez que de la quincaillerie de montage adaptée au poids total
•
des projecteurs et des accessoires.
En plus de la suspension principale, fixez une chaîne de sécurité (ou
•
tout autre dispositif de sécurité homologué) au projecteur. Les chaînes
de sécurité doivent être en mesure de supporter dix fois le poids du
projecteur. Consultez les normes locales pour vous assurer que les
câbles de sécurité respectent toutes les exigences.
Vérifiez que le porte-accessoires est verrouillé et que les élingues de
•
tous les accessoires sont bien attachées avant de monter le projecteur.

Mount the Fixture

You can mount the fixture using a clamp, baby-pin (16 mm) receiver,
or spigot on the yoke (A), or you can set the fixture on the floor or
another flat surface. When suspending the fixture, make sure to
secure the fixture with an appropriate safety cable at the safety cable
attachment point (B).
If necessary, move the adjustable yoke (D in image below) to balance
the fixture. Use a 13 mm socket wrench to loosen the bolt and shift the
yoke position, and then tighten the bolt to secure the yoke.
C
D
Set Up and Focus the Fixture
Note the following safety warnings before use:
Prendre connaissance des avertissements de sécurité
1. Unlock the accessory holder on either side by
2. Slide an accessory into one of the accessory slots.
3. Lock the accessory holder by rotating the accessory
C
4. If necessary, move the adjustable yoke (D) to

Add Accessories

You can use up to two standard accessories (one scrim
and one additional accessory, such as a barn door) in the
accessory holder.
pressing the spring-release and rotating the
accessory holder lock (C).
Add a second accessory in the other slot, if needed.
holder lock back into place.
balance the fixture when using heavier accessories.
Mount the Fixture below
A
.
B
7