Set Up Wireless Control; Set Up Multiverse Wireless Communication; Configure Fixtures Wirelessly Using The Set Light App - ETC fos/4 Series User Manual

Set Up Wireless Control

Set Up Multiverse Wireless Communication

You can use a City Theatrical Multiverse
the fixture. For information on using Multiverse products, see the documentation provided with
the products.
Note:
wireless system, download the Multiverse Wireless Setup Information Guide at
etcconnect.com.
To use Multiverse wireless communication, configure the Multiverse settings on the fixture.
1. Press the Menu button (
and then press the Intensity encoder to select it.
2. Turn the Intensity encoder to set the Universe value.
3. Turn the green encoder to enter the SHoW ID value. This value must match the SHoW ID
value on the Multiverse transmitting device.
4. Turn the blue encoder to enter the SHoW Key value. This value must match the SHoW Key
value on the Multiverse transmitting device.
5. Turn the red encoder to set the Power value. This value sets the power level of the
wireless transmitter on the fixture. Set the value to the minimum level required for
successful communication between transmitters and fixtures. Excess power output can
cause reflections and can degrade performance.
6. Press the green encoder for the Save button (
encoder for the Cancel button (
Configure Fixtures Wirelessly Using the Set Light App
Download the Set Light app to a smartphone with NFC functionality, use the app to set fixture
parameters, and then tap the smartphone to the NFC tag on the fixture to configure it
wirelessly—even when the fixture is not powered on. Or, after you configure the Multiverse
settings on the fixture, use the Set Light app to configure one fixture or multiple fixtures
wirelessly from a smartphone or tablet. (You must be within Bluetooth range of the Multiverse
transmitter or gateway in order to use the app in this mode.) Visit
more information about the Set Light app.
18
For additional guidance and troubleshooting resources when setting up your
), turn the Intensity encoder to navigate to Multiverse Settings,
®
transmitting device to wirelessly configure and control
) to save your settings, or press the red
) to discard your changes.
etcconnect.com/Apps
fos/4 Fresnel User Manual
for