Advertisement
ETC Quick Guide
Desire Fresnel
Focus the Fixture
1. Apply power to the fixture, and wait until the fixture has booted up (the ETC splash screen
displays during boot up).
2. Press any encoder to "wake" the display.
3. What screen is currently displayed?
DMX: Press any encoder to leave the view-only screen, and then press the Intensity
•
encoder to turn on the LED array. The display shows a timeout countdown to indicate how
long the LED array will remain on at 100% intensity. You can turn the Intensity encoder to
reset the timeout countdown to 5 minutes.
All other screens (Studio, Preset, etc.): Press the Intensity encoder to turn on the
•
LED array, and turn the Intensity encoder to adjust the intensity.
4. Adjust the fixture to the desired position.
5. Rotate the zoom knob on either side of the fixture to adjust from spot to flood.
6. Press the Intensity encoder to turn off the LED array.
Use Fixture in DMX Mode
After you connect power and data to the fixture and provide DMX, press the Function button (
use the Intensity encoder to navigate to DMX Mode, and then press the Intensity encoder to select
it. In the DMX screen, you can set the DMX address, DMX mode, and DMX loss behavior.
The DMX screen displays the current DMX values. Press any of the encoders to "wake" the display,
and then press any of the encoders to edit the values. The colors of the encoders correspond to
options on the display. Turn an encoder to modify the corresponding value, and then press the
encoder to save all values on the screen.
Address
Mode
DMX Loss
Press any encoder to wake the display...
Desire Fresnel
DMX
001
3 Ch RGB
HLL
1/3 Red
Address
Mode
DMX Loss
...and then turn an encoder to modify the value in
the matching field. Press an encoder again to save
the value and return to the view-only screen.
Page 5 of 8
DMX
001
3 Ch RGB
HLL 2 Min
1/3 Red
),
ETC
Advertisement
