Disconnecting And Securing The Lathe; Using Lifting Equipment; Mechanical Maintenance Work; Electronics - Optimum OPTI turn TU 3008G Operating Manual

Clamp the turning tool at the correct height and with the least possible overhang.

Turn off the lathe before measuring the workpiece.

The instructions described in these operating instructions must be strictly observed during

assembly, operation, maintenance and repair.
Do not work on the lathe if your concentration is reduced, for example, because you are

taking medication.
Stay at the lathe until all movements have come to a complete standstill.

Use the prescribed personnel protective equipment. Make sure to wear a well-fitting work

suit and, if necessary, a hairnet.

1.12.1 Disconnecting and securing the lathe

Pull the power plug before beginning any maintenance or repair work.
All machine parts as well as all dangerous voltages are switched off.
WARNING!
Live parts and moves of machine parts can injure you or others dangerously! If you
cannot pull the power plug due to required work (e.g. function check), proceed with
extreme caution.

1.12.2 Using lifting equipment

WARNING!
The use of unstable lifting and load suspension equipment that might break under load
can cause severe injuries or even death.
Check to ensure that the lifting and load-suspension equipment are of sufficient load-
bearing capability and are in perfect condition. Fasten the loads properly. Never walk
under suspended loads!

1.12.3 Mechanical maintenance work

After your work, reinstall all guards and safety devices dismantled for maintenance work, such
as:
covers,

safety instructions and warning signs,

grounding cables.

If you remove protection or safety devices, refit them immediately after completing the work.
Check that they are working properly!
1.13

Electronics

INFORMATION
Have the machine and/or the electric equipment checked regularly. Immediately eliminate all
defects such as loose connections, defective wires, etc.
Safety
Version 1.1.6 - 2021-9-17 Translation of original instruction
TU3008G GB
15