Manufacturer's Information; Delivery; Packaging; Transport - GEM eSyStep Q50 Operating Instructions Manual

8 Manufacturer's information

8.1 Delivery

● Check that all parts are present and check for any dam-
age immediately upon receipt.
The product's performance is tested at the factory. The
scope of delivery is apparent from the dispatch documents
and the design from the order number.

8.2 Packaging

The product is packaged in a cardboard box which can be re-
cycled as paper.

8.3 Transport

1. Only transport the product by suitable means. Do not
drop. Handle carefully.
2. After the installation dispose of transport packaging ma-
terial according to relevant local or national disposal reg-
ulations / environmental protection laws.

8.4 Storage

1. Store the product free from dust and moisture in its ori-
ginal packaging.
2. Avoid UV rays and direct sunlight.
3. Do not exceed the maximum storage temperature (see
chapter "Technical data").
4. Do not store solvents, chemicals, acids, fuels or similar
fluids in the same room as GEMÜ products and their
spare parts.

9 Installation

9.1 Preparing for installation

WARNING
The equipment is subject to pressure!
▶ Risk of severe injury or death.
Depressurize the plant.
●
Completely drain the plant.
●
WARNING
Corrosive chemicals!
▶ Risk of caustic burns.
Wear suitable protective gear.
●
Completely drain the plant.
●
CAUTION
Hot plant components!
▶ Risk of burns.
Only work on plant that has cooled
●
down.
www.gemu-group.com
Use as step.
▶ Damage to the product.
▶ Risk of slipping-off.
Choose the installation location so that the product can-
●
not be used as a foothold.
Do not use the product as a step or a foothold.
●
Suitability of the product.
▶ The product must be appropriate for the tube's operating
conditions (medium, medium concentration, temperature
and pressure) and the respective ambient conditions.
Tools
▶ The tools required for installation and assembly are not
included in the scope of delivery.
Use appropriate, functional and safe tools.
●
1. Ensure the product is suitable for the relevant application.
2. Check the technical data of the product and the materials.
3. Keep appropriate tools ready.
4. Use appropriate protective gear as specified in plant op-
erator's guidelines.
5. Observe appropriate regulations for connections.
6. Installation work must be performed by trained personnel.
7. Shut off plant or plant component.
8. Secure the plant or plant component against recommis-
sioning.
9. Depressurize the plant or plant component.
10. Completely drain the plant or plant component and allow
it to cool down until the temperature is below the media
vaporization temperature and cannot cause scalding.
11. Pay attention to the installation position (see chapter "In-
stallation position").

9.2 Installation position

The installation position of the product is optional.

9.3 Installing the valve on the housing

1. Carry out preparations for installation (see chapter "Pre-
paring for installation").
2. Secure the valve body to the housing using four screws.
3. Re-attach or reactivate all safety and protective devices.
13 / 53
9 Installation
CAUTION
NOTICE
NOTICE
GEMÜ Q50 eSyStep
Positioner (Code S0, S5, S6)