Events - GEM eSyStep Q50 Operating Instructions Manual

11 Specific data IO-Link (pin 6)
11.4.36 Analog output
The analog output function can be set with the Analog Output parameter.
Index Sub- Off- Access
In- set Rights
dex
0xBA 1 0 R/W
2 8 R/W
3 16 R/W
4 32 R/W
Description of parameter values
Index name
Analog output

11.5 Events

The following IO-Link events can be transmitted.
Event
Device Hardware Fault
Motor Unable To Move
Device Temperature Over-Run
Emergency Power
Primary Supply Voltage Under-Run
Potifail Close
Potifail Open
Description – Events
Event
Device Hardware Fault
0x5000
Motor Unable To Move
0x8CE0
GEMÜ Q50 eSyStep
Positioner (Code S0, S5, S6)
Length Index name
1 bit Analog output
2 bits
16 bits
16 bits
Parameter Values
Direction 0
1
Type 0
1
2
Min. 0 to Max
(0.0% to Max)
Max. Min to 1000
(Min to 100%)
Description
The event occurs when a
hardware fault is detected.
The event occurs when the
motor is blocked.
Parameter Type
Direction Boolean
Type uint:8
Min. uint:16
Max. uint:16
Specify direction of the set value output.
0 = Rise (rising)
1 = Fall (falling)
Determine signal output.
0 = 0 to 20 mA
1 = 4 to 20 mA
2 = 0 to 10 V
Determine minimum value of the output.
Determine maximum value of the output.
Mode
App/Disapp Error
App/Disapp Error
App/Disapp Warning/Error
App/Disapp Warning
App/Disapp Error
App/Disapp Warning
App/Disapp Warning
Possible cause
Fault in valve position detec-
tion.
Parameter can no longer be
read when switching the
device on.
Valve is blocked (for example,
solid stuck in valve).
Valve corroded (rusted in
place).
End position can no longer be
reached (after replacing the
diaphragm).
42 / 53
Default Values
0 0
1
1 0
1
2
0 0 to Max
(0.0% to Max)
1000 Min to 1000
(Min to 100%)
Description
Type Code
0x5000
0x8CE0
0x4210
0x5100
0x5111
0x8CA5
0x8CA4
Troubleshooting
Contact GEMÜ Support
Check valve
Carry out initialization if valve
is OK
www.gemu-group.com