Table of Contents
Advertisement
Storage
Storage Safety
•
Shut off the machine, remove the key, and wait
for all movement to stop before you leave the
operator's position. Allow the machine to cool
before adjusting, servicing, cleaning, or storing it.
•
Do not store the machine or fuel container where
there is an open flame, spark, or pilot light, such
as on a water heater or other appliance.
Storing the Machine
1.
Park the machine on a level surface.
2.
Engage the parking brake.
3.
Shut off the engine and remove the key.
4.
Clean the dirt and grime from the entire machine,
including the outside of the cylinder-head fins of
the engine and blower housing.
Important:
You can wash the machine
with mild detergent and water. Do not use
power-washing equipment to wash the
machine. Pressure washing the machine
may damage the electrical system or wash
away necessary grease at friction points.
Avoid excessive use of water near the control
panel, lights, engine, and the battery.
5.
Inspect the brakes; refer to
Brakes (page
52).
6.
Service the air cleaner; refer to
Cleaner (page
36).
7.
Grease the machine; refer to
Machine (page
32).
8.
Change the engine oil; refer to
Engine Oil (page
9.
Check the tire pressure; refer to
Tire Pressure (page
10.
For storage over 30 days, prepare the fuel
system as follows:
A.
Add a fuel stabilizer/conditioner to fresh fuel
in the tank. Do not use an alcohol-based
fuel stabilizer (ethanol or methanol).
Important:
stabilizer/conditioner longer than
the duration recommended by the
fuel-stabilizer manufacturer.
B.
Run the engine to distribute conditioned fuel
through the fuel system for 5 minutes.
C.
Shut off the engine, allow the engine to
cool, and drain the fuel tank.
Inspecting the
Servicing the Air
Greasing the
Servicing the
38).
Checking the
15).
Do not store fuel containing
Note:
Dispose of fuel properly. Recycle as
according to local codes.
D.
Start the engine again and run it until it
stops.
E.
Choke the engine.
F.
Start and run the engine until it does not
start again.
11.
Remove the spark plug and check their
condition; refer to
(page
39).
12.
With the spark plugs removed from the engine,
pour 15 ml (2 tablespoons) of engine oil into the
spark-plug hole.
13.
Use the electric starter to crank the engine and
distribute the oil inside the cylinder.
14.
Install the spark plug(s) and tighten it to
recommended torque; refer to
Spark Plug (page
Note:
Do not install the wire on the spark
plug(s).
15.
Remove the battery from the chassis, and
charge it fully; refer to
(page
43).
Note:
Do not connect the battery cables to the
battery posts during storage.
Important:
charged to prevent it from freezing and being
damaged at temperatures below 0°C (32°F).
A fully charged battery maintains its charge
for about 50 days at temperatures lower than
4°C (40°F).
16.
Check and tighten all fasteners. Repair or
replace any part that is damaged.
17.
Paint all scratched or bare metal surfaces
with paint available from your authorized Toro
distributor.
18.
Store the machine in a clean, dry garage or
storage area.
19.
Remove the key from the key switch and put it in
a safe place out of the reach of children.
20.
Cover the machine to protect it and keep it clean.
55
Servicing the Spark Plug
Servicing the
39).
Removing the Battery
The battery must be fully
Advertisement
Table of Contents
