Mircom TX3 Series Installation And Operation Manual page 20

2.3.10 Controller options
The following controller options are configurable:
Card format. The following card formats are supported:
•
•
•
•
•
•
•
•
•
•
•
•
Send real time logs. If enabled, only the real time logs are sent to the PC.
Interlock feature. If enabled, door B cannot be unlocked until door A is locked
and closed. Door A cannot be unlocked until door B is locked and closed.
Facility code. Facility code is set to any value is used in the facility code mode.
The default is 0.
2.3.11 Access point options
The following access point options are configurable:
Auto relock. Enabling this option locks the door when the door closes before the
door open timer or extended door timer expires. Disabling this option locks the
door, but only after the expiration of door open timer or extended door open
timer.
Deduct usage count. For cards designated as "temporary" (that is, the usage
counter option is enabled and set to a value below 255), this option decreases the
usage counter by one every time this card is used at the access point. When the
usage counter reaches zero, the card deactivates.
20 TX3-CX Card Access System Installation and Operation Manual
LT-980 Copyright 2019
26-bit Wiegand SIA
32-bit CSN
34-bit Awid
35-bit HID corporate 1000
35-bit Indala
36-bit HID Simplex
36-bit Keyscan C15001
37-bit Cansec
37-bit HID 10304
37-bit Mircom
39-bit Kantech XSF
50-bit RBH
Configurable Features
Version 5.2