Sencore OmniHub 6 User Manual page 77

OmniHub 6/6D – User Manual
Clicking on the icon will show you the NIT setting where you can create and add NIT
Network and NIT Stream.
For NIT Stream, you can create Cable Descriptor and Logical Channel Number LCN.
You need to Add and Input first the correct Original Network ID and TS ID. Once it is
done, click on the plus icon "+" under Operation and select the Descriptor you want to
add.
For Cable Descriptor, this is used for the STB to scan all configured frequencies on the
network given that the STB triggering Frequency is set where the NIT frequency is
created. e.g., If the NIT is created in TS ID 10 with frequency 539MHz and 5057Kbaud
Symbol rate, the STB "Autosearch Setup" or setting should has the same parameters for
Frequency and Symbol rate.
Page 77 of 113