Sencore OmniHub 6 User Manual page 73

Delay (ms)
Service
Parameter
Program Name
Provider Name
Video PID
Shelter
Parameters
Shelter
Y
Height
3.4.6.2 Module Output
Direct IP output is specifically for encoding single program and outputting directly to IP. It
will not occupy multicast bandwidth of the baseboard.
If you want to use IP output channel on the encoder module and the baseboard IP
module at same time, you should avoid the multicast IP addresses conflicts. If there are
two same IP addresses enabled meantime, all the multicast videos will be affected.
• Destination IP Address and Destination Port: for multicast IP addresses or
unicast IP addresses and ports.
• Enable Destination MAC: Generally, you do not need to enable this option. This
is reserved for exceptional cases when the unicast stream cannot be received by
with the unicast IP addresses. You can enable destination MAC and streaming
out by setting Destination MAC.
The second eth is reserved to output IP streams in another different VLAN. Enabling the
second eth and set IP Address, Subnet Mask, Default Gateway in the same segment
of the Unicast IP (the another different VLAN), you can output the Unicast stream to the
another VLAN.
To use Multiplexing mode on service level:
1. Click on (pencil) icon. There will always be a BaseBoard selection for the IP
output and other Output options depending on the module inserted.
2. Select the correct Output and Channel you want to output the service to.
3. Check Multiplex on the channel you want to outputt. You can output multiple
services to one channel or output one service to multiple channels.
Page 73 of 113
OmniHub 6/6D – User Manual
-2000~2000
Range
String between 1~31
String between 0~31
32~8190
Range
Enable/Disable
0~600 (Dual)
10~800 (Dual)
Service
Parameter
Audio PID 32~8190
PCR PID 32~8190
PMT PID 32~8190
Shelter
Parameters
X
Width
Color
Range
Range
0~800 (Dual)
10~800 (Dual)
White/Black/Bl
ue/Green/Red