Sencore OmniHub 6 User Manual page 29

Basic Settings tab displays the configuration page of the IP output. You can enable the
TS and set the output IP Address, IP port and Protocol of the Destination IP multicast.
.
To enter many IP addresses, use the Batch Setting
following fields. You can only set the destination IP address when the IP addresses are
in a consecutive order
Click the Apply button
Service Configuration tab display the page where you can check/edit output TS or
services that are part of output IP streams. Streams can originates either from IP input,
Page 29 of 113
OmniHub 6/6D – User Manual
on the right side to make the change take effect.
button and fill in the