Table of Contents
Advertisement
• Destination IP Address and Destination Port: for multicast IP addresses or
unicast IP addresses and ports.
• Enable Destination MAC: Generally, you do not need to enable this option. This
is reserved for exceptional cases when the unicast stream cannot be received
with the unicast IP addresses. You can enable destination MAC and streaming
out by setting Destination MAC.
• Advance Setting (only available in OHE6-HDMI-00):
The second eth is reserved to output IP streams in an another different VLAN. Enabling
the second eth and set IP Address, Subnet Mask, Default Gateway in the same
segment of the Unicast IP (the another different VLAN), you can output the Unicast
stream to the another VLAN.
To use Multiplexing mode on service level
1. Click on
(pencil) icon. There will always be a BaseBoard selection for the IP
output and other Output option depending on the modules inserted.
2. Select the correct Output and Channel you want to output the Service.
3. Check Multiplex for the Channel you want to output,. You can output multiple
services in same channel or output same service in multiple channels.
Page 50 of 113
OmniHub 6/6D – User Manual
OHE6-HDMI-R01
Advertisement
Table of Contents
