Table of Contents
Advertisement
Click the Apply button
Name
QAM Mode
Bandwidth
Symbol Rate (KBaud)
PSI/SI Interval (ms)
3.5.1.3
Module Output
QAM Output will be different from the Receiver and Encoder module. Since the QAM
module is an output module like IP output, all service configured in receiver, encoder
and IP input will be seen here.
Every Channel in QAM output has Original Network ID and TS ID. It is important to
identify the TS ID properly. Labeling the TS will help you to monitor your output services.
It
is
also
important
When you click on the Service Settings, this is the screen you will see first.
On the Left side, you will see the list of TS where there are output services. If the TS or
Channels are enabled but no Service Output, it will not be listed here.
You will also see the Original Network ID and TS ID where you can modify the details
and below will be the list of the service in the Selected TS. Initially, TS 1 is selected
when you first select the Service Configuration tab.
Clicking on the Program name under the TS will show the Programs Basic Parameter
where you can modify each detail.
Page 76 of 113
OmniHub 6/6D – User Manual
on the right side for the changes to take effect.
Range
ANNEX A/ ANNEX B
6M, 7M, 8M
4400~6956
50~10000
for
creating
NIT
Name
Range
RF level
0~63
Frequency (KHz)
48000~858000
Constellation
QAM16/32/64/128
/256
for
LCN
and
Cable
Descriptors.
Advertisement
Table of Contents
