Table of Contents
Advertisement
3.3.5.3 Modules Service Configuration
Service Configuration tab displays the configuration page where you can manage the
received services and output them to their designated interface. Configuration steps for
IP input and all receiving and encoding modules in OmniHub 6/6D are mostly the same.
First, you need to scan the port of each TS with LOCKED signal status. Each port might
be scanned automatically or need to be scanned manually one at a time when its source
signal is replaced.
After scanning each channel, you can output each transport stream or service by
clicking the icon
and
or a service/s from the input channel toward the available output channel (IP or RF).
Two types of routing are possible
1. Bypass mode. In this mode, routes can only be done when outputting a whole
input transport stream towards an output TS channel, this cannot be done when
outputting a single service only. Bypass mode activation will not allow other
services from other input TS to be mixed in the current TS output. Any attempts
of routing other streams/services towards this channel will result in "this channel
won't be available at this time".
2. Multiplex mode is used to create a new SPTS or MPTS. This mode allows the
administrator to perform the following operations:
a. Route a single service towards an output channel to create SPTS.
b. Route services towards a single output channel to create MPTS.
c. Route service/s AND stream/s from multiple channels towards a single
output channel to create MPTS.
Page 40 of 113
OmniHub 6/6D – User Manual
below "Destination Settings". You can route the whole stream
Service Configuration page interface
Advertisement
Table of Contents
