Supermicro SuperServer E102-9W-C User Manual page 64

SuperServer E102-9W-C User's Manual
Storage Option ROM/UEFI Driver
Select UEFI to load the EFI driver for system boot. Select Legacy to load a legacy driver for
system boot. The options are Do not Launch, EFI, and Legacy.
Serial ATA Port 0 - 2
This feature displays the information detected on the installed SATA drive on the particular
SATA port.
•
Model number of drive and capacity
•
Software Preserve Support
Serial ATA Port 0 - 2 Hot Plug
Set this feature to Enable for hot plug support, which will allow the user to replace a SATA
drive without shutting down the system. The options are Disabled and Enabled.
Serial ATA Port 0 - 2 Spin Up Device
Set this feature to enable or disable the PCH to initialize the device. The options are
Disabled and Enabled.
Serial ATA Port 0 - 2 SATA Device Type
Use this feature to specify if the SATA port specified by the user should be connected to a
Solid State Drive or a Hard Disk Drive. The options are Hard Disk Drive and Solid State
Drive.
PCH-FW Configuration
ME Firmware Version
ME Firmware Mode: Normal Mode
ME Firmware SKU: Corporate SKU
ME FW Image Re-Flash
Use this feature to update the Management Engine firmware. The options are Disabled and
Enabled.
Manageability Features State
Enabled this feature to allow system administrators to configure the ME BIOS extension
(MEBx) configuration settings. The options are Disabled and Enabled.
64