Using Analog Trunk As Failover; Figure 11: Add Analog Trunk As Failover - Grandstream Networks UCM6 Series Manual

Once the outbound rule is created, it can be edited anytime by clicking on
icon.

Using Analog Trunk as Failover

Failover Trunks are used when the primary trunk fails in order to assure the continuity of external calling service
for extensions.
User can setup their Analog Trunk as failover for another trunk by following the below steps:
1. Go to Extension / TrunkOutbound Routes.
2. Click on next to your Primary Trunk.
3. Scroll down to Use Failover Trunk, and click on Add to add a failover trunk.
4. Users can select then the Trunk to be set as failover as shown in figure below.
5. Click on
6. Click on
7. Click on to edit, or

Figure 11: Add Analog Trunk as Failover

to add another failover trunk.
to arrange the order. If there are multiple trunks set as failovers.
to delete the Trunk from Failover list.
UCM6XXX Analog Trunks Guide
icon or deleted by clicking on
P a g e | 14