Graco E-Flo Installation Manual page 53

b. Disconnect the wires inside the Driver housing.
See F . 47.
IG
F . 47: Wires in Driver Housing
IG
c. Loosen the cord grip (CG).
d. Remove wires from Driver housing by pulling
them through the cord grip (CG).
e. Disconnect the cables connected to ports 1-6
on the side of the Driver (AB), shown in F
CG
F . 48
IG
F . 49
IG
333586E
5. Disconnect Driver (AB):
a. D200 3 in. and D200s 6.5 in. ram supply units:
125
Lift Ring
F . 50: 55 Gallon Platen
IG
. 49.
IG b. D60 3 in. ram supply units: Remove screws
AB
HC
F . 51: D60 with Ram
IG
Attach a secure hoist to the driver lift ring.
Loosen nut (125) below crossbar. Use wrench
to hold lift ring adapter (127) in place and loosen
threaded rod (126) above crossbar with another
wrench. See F . 50.
IG
126
(255) and washers (256) from mounting plate
(259). Using a secure hoist, lift the Driver (AB)
from the mounting plate (259). See F
Repair
125
127
. 51.
IG
259
256
255
53