Graco E-Flo Installation Manual page 21

Low Level Sensor Kit, 25E447
NOTE: The Low Level Sensor Kit is an optional
accessory for Single Ram Systems, and a required
accessory for Tandem Ram Systems.
To install the Low Level Sensor:
1. Turn the Disconnect Switch (AZ) OFF.
2. Disconnect cable from the empty level sensor (EL).
3. Mount the low level sensor (LL) on the mounting
bracket.
4. Connect the splitter cable (SP) to the previously
disconnected cable.
5. Connect the splitter cable (SP) lead labeled EMPTY
to the empty level sensor (EL).
6. Connect the splitter cable (SP) lead labeled LOW to
the low level sensor (LL).
7. Raise/lower the low level sensor (LL) to the desired
position to activate the sensor.
8. See the E-Flo iQ Supply System Operation manual
to set up the low level sensor.
LL
EL
333586E
SP
Supply Unit Component Identification
21