Adjusting The Parking Brake; Replacing The Light Bulbs - Husqvarna P 520D With cabin Operator's Manual

Adjusting the parking brake

Make sure the parking brake is properly adjusted by placing
the machine on a slope.
Apply and lock the parking brake.
When the machine does not stand still, the parking brake
should be adjusted according to the following.
1 Position the machine on flat ground.
2 Make sure the parking brake is released.
3 Adjust so there is 1 mm play between the outer cable and
the adjuster screw when you pull the outer cable.
Adjust the adjuster screw using the nuts.
4 Tighten the nuts carefully to prevent damaging the
adjuster screw.
5 The parking brake should be checked again after the
adjustment has been made.
WARNING! A poorly adjusted parking brake
!
can result in reduced braking ability.

Replacing the light bulbs

For information about the bulb type, see Technical Data.
Low beam, parking lights, turning lights
Unscrew the 4 screws holding the lamp insert.
Low beam
• Loosen the cables from the lamp.
32 –
English
MAINTENANCE AND SERVICE
• Loosen the lamp by holding down the spring lock.
• Insert the new lamp.
• Refit the cables and lamp insert.
Parking lights
• Loosen the cables from the lamp.
• Lift out the bulbs from the insert.
• Insert the new lamp.
• Refit the cables and lamp insert.
Turning lights
• Loosen the cables from the lamp.
• Loosen the lamp from the lamp insert by turning the lamp
counterclockwise.
• Insert the new lamp.
• Refit the cables and lamp insert.