Scale Operations; Weight Unit Switching; Entering Tare Weights; One-Touch Tare, Tare Unknown - Rice Lake Counterpart CP-10 User Manual

5.0

Scale Operations

The following contains detailed operator instructions for Counterpart, including instructions on how to enter tare
weights, toggle between net and gross weight, enter unit weights, perform inventory accumulation and reduction,
and toggle between scales. All operator instructions are conducted with the scale in the operation mode that is the
weighing or normal mode.
Counting scale accuracy is determined by:
• Sample size (number of pieces)
• Total sample size as a percentage of full scale capacity
• Piece-to-piece weight variation
As a general rule when determining sample size of fairly uniform pieces, the larger the sample size, the greater the
total sample weight, and therefore, the better the counting accuracy. Selecting the smallest capacity scale that can
obtain the highest counting resolution should be considered, but should not sacrifice the capacity required for the
heaviest container of parts. For this kind of application, a dual-platform scale may be the best selection. There is a
direct relationship between piece-to-piece weight variation (non-uniformity) and counting accuracy.
Therefore, elimination of the piece-to-piece weight variations can be accomplished by:
1. Isolating the sample used to calculate the unit weight and using the same sample to re-check the scale.
2. Recalculating the unit weight from lot-to-lot of parts. Parts manufactured on one machine may vary
slightly from another machine relative to weight.
3. Tightening the manufacturing tolerances on the parts reduces piece weight variations and increases count
accuracy.
The Stand-by Screen
At the stand-by screen the
platform is illuminated (Scale 1 or 2).
5.1

Weight Unit Switching

The weight units displayed can be changed between primary, secondary and tertiary units during weighing
operations by pressing the
5.2

Entering Tare Weights

Tare weights can be entered in the scale by one of two methods: one-touch tare or digital tare. Digital tare is used
when the tare weight is already known while one-touch tare is used when the tare weight is unknown. If you call up
an Item Code already programmed into the Counterpart memory and you have a tare weight stored for that Item
Code, the tare weight stored with the Item Code will override one entered digitally or by using the

5.2.1 One-Touch Tare, Tare Unknown

1. If the tare weight value is not known, place the item to be tared on the scale and press
display should now show
2. Remove the item from the scale. The weight display should show a negative weight value (weight of the
tared container, box, or item).
3. To clear the tare weight, press
annunciator will no longer be illuminated.

5.2.2 Digital Tare, Tare Weight Known

1. If the tare weight value is known, use the numeric keypad to key in the value and then press
annunciator will illuminate.
2. To reset the tare to zero, press
the annunciator is lit
Zero
and
WEIGHT, UNIT WEIGHT,
key.
UNITS TOGGLE
and the annunciator should illuminate.
0 Net
with no weight on the scale. The
TARE
again with no weight on the scale while the scale is at gross zero and
TARE
.
displays show zeros and the annunciator for the
QUANTITY
scale should be at gross zero.
key.
TARE
. The weight
TARE
The
Net
. The
TARE Net
Scale Operations 59