Aligning Inside Cabinetry - Fisher & Paykel ACTIVESMART RS32A72 Installation Manual

IMPORTANT!
Supplied tools
Ensure all four corners of the appliance is supported firmly onto the floor
●
to eliminate any movement.
DO NOT install the appliance on a soft, uneven, or unlevelled floor
●
to avoid twisting the appliance and poor door sealing.
Hex key
We recommend to use A 4mm hex key.
●
One turn of height adjusting nuts is equivalent to 1mm height adjustment.
●
Note: Maximum height adjustment is 13/16" (20mm).
Tools
Align appliance inside the cabinetry
1 Centre the appliance within the alcove, using the adjacent
walls as a guide.
Ruler
2 Raise the front of the appliance until the fixing brackets
contact the ceiling of the enclosure (A).
Turn the front and rear adjusting nuts (B) clockwise to
z
raise the roller or counter-clockwise to lower the roller.
3 To achieve correct alignment between front of the doors
and adjacent cabinetry panels, turn the adjusting nuts
alternately between front and rear rollers.
Powered driver (optional)
4 Check the gaps top and bottom, left and right by placing a
ruler on the front of the appliance.
Ensure the gaps between appliance and adjacent
z
cabinetry are even on both sides (C).
This step will help ensure the appliance is level with the
z
adjacent cabinetry
Cross-head screwdriver
5 Gently push the front of the appliance to check
the stability
!8

ALIGNING INSIDE CABINETRY

Place a ruler on the
front of the appliance to
check flushness top and
bottom, left and right
B
If using a powered driver, use low torque setting to avoid the nut
●
disengaging from the rod and damaging the leveling system. If the nut
disengages, use the hex key to realign with rod.
Ensure that the top, bottom and side gap differences are not greater than
●
1.5mm to achieve correct alignment.
Final alignment will be achieved once door panels have been installed
●
and the appliance is pushed back to sit flush with the cabinetry.
C
Rear roller adjustment
Front roller adjustment
A
B
25