Align Your Product Inside Cabinetry - Fisher & Paykel ACTIVESMART RS36A72 Installation Manuals

IMPORTANT!
Ensure that all four corners of the refrigerator are supported firmly onto the floor to
● ●
eliminate any movement.
Installing the refrigerator on a soft, uneven, or not level floor may result in twisting
● ●
of the product and poor door sealing.
Raise the refrigerator using a 7/16" (11mm) hex socket or 3/16" (4mm) hex key.
● ●
One turn of height adjusting nuts is equivalent to 1/16" (1mm) height travel.
Turn the front and rear adjustment nuts
1
(A) using a hex key to extend the feet
until it engages the floor.
– Clockwise turn raises the height
and counter-clockwise turn lowers
the height.
Continue turning the adjusting nuts
2
alternately between front and rear feet
to align the front of the doors top to
bottom on both sides, and until you
achieve the correct alignment.
– Depending on your installation
design, alignment may be flush
with your adjacent cabinetry or
your framework.
A
18
!3

ALIGN YOUR PRODUCT INSIDE CABINETRY

C
Rear roller adjustment
Front roller adjustment
Note: Maximum turn is 13/16" (20mm).
Use low torque setting to avoid damage to height adjustment system.
● ●
Failure to achieve flushness across all sides greater than 1/16" (1.5mm) can lead to
● ● Add ruler to show ushness x 4?
difficulties achieving final alignment. Final alignment will be achieved once door panels
have been installed and the refrigerator is pushed back to sit flush with cabinetry.
Place a ruler on the front of the product (B) to check flushness
3
top and bottom, left and right. Check the gaps between
refrigerator and adjacent cabinetry are even on both sides (C).
– This step will help ensure the refrigerator is level with the
adjacent cabinetry.
Gently push the front of the product to check the stability.
4
Place a ruler on the
front of the product to
check flushness top and
bottom, left and right.
A
B