Fisher & Paykel ACTIVESMART RS32A72 Installation Manual page 37

IMPORTANT!
Door panel
B
Follow these steps to avoid difficulties in door panel adjustment and cosmetic cap fitment.
attachment ●
kit
Adjust the door panels
#8Gx16 countersunk
Push the appliance into the cavity until the door panels are flush
1
screw (2)
with adjacent cabinetry.
Place a ruler on the front of the appliance to check flushness top
2
and bottom, left and right.
Tools
Hex key
#8 x 16
Mush Washer
Twin Thread
Philips Screw
FPA spanner
Cross-head screwdriver
Powered driver (optional)
Ruler
@0 DOOR PANEL INSTALLATION — CUSTOM
2
3
4
5
A
Each door panel has full axis adjustment to ensure flushness
with adjacent walls. To adjust the height of the panel, turn
the stud clockwise to raise or counter-clockwise to lower the
door panel (A).
Once satisfied with the alignment, secure M8 studs with M8
washer and M8 nut (B). The top of the stud must remain below
the top face of the door panel.
Secure side bracket forks by tightening
side screws (C).
Repeat for all door panels.
Note:
– For depth adjustment, loosen the
side screws, adjust the panels and
then retighten once satisfied.
– Further adjustment of door panels
can be achieved by removing door
panels then loosening the fixing
screws for the hanging bracket and
moving the bracket sideways to suit.
Loosen the M8x16 crosshead screw (D)
so that locking bracket can slide freely
back to front.
– Slide the locking bracket out until it
touches the back of the door panel.
Fully tighten the screw.
– Screw in place using a #8x16 screw
through one of the three slotted
holes.
B
C
D
35