IMPORTANT!
Ensure that all four corners of the refrigerator are supported firmly onto the floor
●
●
to eliminate any movement.
Installing the refrigerator on a soft, uneven, or not level floor may result in twisting
●
●
of the product and poor door sealing.
Raise the refrigerator using a 11mm hex socket or 4mm allen key. One turn of height
●
●
adjusting nuts is equivalent to 1mm height travel.
Turn the front and rear adjustment nuts
1
(A) using a allen key to extend the feet
until it engages the floor.
– Clockwise turn raises the height
and counter-clockwise turn lowers
the height.
Continue turning the adjusting screws
2
alternately between front and rear feet
to align the front of the doors top to
bottom on both sides, and until you
achieve the correct alignment.
– Depending on your installation
design, alignment may be flush
with your adjacent cabinetry or
your framework.
A
20
!5
ALIGN YOUR PRODUCT INSIDE CABINETRY
C
Front roller adjustment
Rear roller adjustment
Note: Maximum turn is 20mm.
Use low torque setting to avoid damage to height adjustment system.
●
●
Failure to achieve flushness across all sides greater than 1.5mm can lead to difficulties
●
●
achieving final alignment. Final alignment will be achieved once door panels have
been installed and the refrigerator is pushed back to sit flush with cabinetry.
Place a ruler on the front of the product (B) to check flushness
3
top and bottom, left and right. Check the gaps between
refrigerator and adjacent cabinetry are even on both sides (C).
– This step will help ensure the refrigerator is level with the
adjacent cabinetry.
Gently push the front of the product to check the stability.
4
Place a ruler on the front of
the product to check flushness
top and bottom, left and right.
A
B