Network Connection Between Procommander Lx And Pro I/O - WEIGL ProCommander LX Instruction Manual

Network connection between ProCommander LX and Pro I/O

14 Network connection between
ProCommander LX and Pro I/O
The ProCommander LX commands an intern chart, which
associate each Sub-Device-ID of a Pro I/O module with an
address.
By default for all modules broadcast addresses are adjusted,
which read in all commands, independently of the adjusted
address of the Pro I/O modules. Because of the Sub-Net
address adjustment (A1, A2, ...) of a device, each Pro I/O
module analyze only the own commands.
If it's necessary to assign individual
conflicts with other devices in the network can be avoided, the
values of the charts can be modified.
Two commands are available for that. On the one hand the
global command !swi...# and on the other hand the individual
command !spi...#.
With !swi...# a consecutive numbering takes place for all Pro
I/O modules, beginning with the entered
!spi...# each module can be assigned to an individual address.
These commands can be assigned via the configurator.
IP addresses, so that
start-IP address. With
IP
IP
85