Network Connection Between; Procommander ® Ltc And Pro I/O - WEIGL ProCommander LTC Instruction Manual

Network connection between ProCommander LTC and Pro I/O

13 Network connection between

ProCommander
The ProCommander
associate each "Sub-Device-ID" of a Pro I/O module with an
IP address.
By default for all modules broadcast addresses are adjusted,
which read in all commands, independently of the adjusted
IP address of the Pro I/O modules. Because of the Sub-Net
address adjustment (A1, A2, ...) of a device, each Pro I/O
module analyze only the own commands.
If it's necessary to assign individual
conflicts with other devices in the network can be avoided, the
values of the charts can be modified.
Two commands are available for that. On the one hand the
global command !swi...# and on the other hand the individual
command !spi...#.
With !swi...# a consecutive numbering takes place for all Pro
I/O modules, beginning with the entered
!spi...# each module can be assigned to an individual address.
These commands can be assigned via the configurator.
LTC and Pro I/O
®
LTC commands an intern chart, which
®
IP addresses, so that
start-IP address. With
99