Analogue Min- And Max-Value - WEIGL ProCommander LX Instruction Manual

Hide thumbs Also See for ProCommander LX:

Table of Contents

8 Analogue MIN- and MAX-value

For each of the four 0-10V analogue-channels, the four servo-

channels, as well as for the eight PWM-channels a minimum and

maximum value can be adjusted.

So the voltage range, servohub or the PWM-value can be

circumscribed. Hereby, it is important to consider that after the

start-up all four analogue-values have the voltage level 0V. The

eventually adjusted minimum value will be set at the output

immediately after the booting of the ProCommander LX. This

takes a few milliseconds.

!san...# is the command for the minimum level. The

resolution of values is in 0.01%-steps from 0 to 10000. The

command !san1=1055# sets for the analogue-channel 1 to a

minimum value of 10.55%. The minimum value must not be

higher than the maximum value. If a higher value will be entered

the minimum value will be set to the adjusted maximum value.

In this case, the analogue-output remains at the adjusted value.

!sax...# adjust the maximum value, whereby the same

criteria as for the minimum value apply. The resolution is also in

0.01% steps from 0-10000 and the maximum value must not be

less than the minimal value. !sax2=9023# sets for the

analogue-channel 2 the maximum value to 90.23%. The

maximum value must not be lower than the minimum value. If

a lower value is entered, the maximum value will be set to the

level of minimum value.

Analogue MIN- and MAX-value

Table of Contents