Otto Bock 8S500 Instructions For Use Manual page 8

► Only clean the product according to the cleaning instructions provided in the instructions for
use.
Light soiling
Materials required:
>
warm water, soap, cloth, lint-free cloth
1) Clean the product with warm water, soap and a cloth.
2) Rinse off soap residues with water.
3) Dry the product with a lint-free cloth and allow it to air dry fully.
Heavy soiling
Materials required:
>
640F12 Special Cleaner, 640F13 Pump Sprayer, clean, undyed cloth (e.g. cellulose, linen),
water, lint-free cloth
1) NOTICE! Clean the product promptly to avoid heavy dirt from permanently contaminat­
ing the material.
Spray the special cleaner on to the soiled area of the product and leave to take effect for a
short time.
2) Wipe off the dirt from the product with a clean, undyed cloth using light pressure.
3) Rinse off residual cleaner and dirt with water.
4) Dry the product with a lint-free cloth and allow it to air dry fully.
Removal of nail varnish
Materials required:
>
Nail varnish remover (acetone-fee), clean, undyed cloth (e.g. cellulose, linen), water, lint-free
cloth
1) Remove the nail varnish from the product with nail varnish remover and a clean, undyed cloth,
using light pressure.
2) Rinse off residual cleaner and dirt with water.
3) Dry the product with a lint-free cloth and allow it to air dry fully.
5 Disposal
This product may not be disposed of with regular domestic waste in all jurisdictions. Disposal that
is not in accordance with the regulations of the country where the product is used may have a det­
rimental impact on health and the environment. Please observe the information provided by the
responsible authorities in the country of use regarding return, collection and disposal procedures.
6 Legal information
All legal conditions are subject to the respective national laws of the country of use and may vary
accordingly.
6.1 Liability
The manufacturer will only assume liability if the product is used in accordance with the descrip­
tions and instructions provided in this document. The manufacturer will not assume liability for
damage caused by disregard of this document, particularly due to improper use or unauthorised
modification of the product.
6.2 CE Conformity
This product meets the requirements of the European Directive 93/42/EEC for medical devices.
This product has been classified as a class I device according to the classification criteria out­
lined in Annex IX of the directive. The declaration of conformity was therefore created by the man­
ufacturer with sole responsibility according to Annex VII of the directive.
8 | Ottobock