Table of Contents
Advertisement
Function Introduction/Names of Parts
Display and Key Panel
10
Status display
Displays the following information.
RECORD............ Illuminates while recording measured values.
KEY LOCK......... Illuminates when key lock is enabled.
MATH................. Illuminates when computation on the computation function (/M1 option)
is in progress.
CHART END...... Illuminates when the chart paper is out (/F1 option).
ALARM 1 to 24.. Illuminates when an alarm is occurring on channels 1 to 24.
Main display
Displays the measured values. Also, displays the setup screen when
setting functions.
RECORD KEYLOCK MATH CHARTEND ALARM
CHARACTER
RCD
MENU
Seven keys are available.
For all keys except RCD, functions marked above the keys are enabled when
setting functions or when the FUNC key or the DISP MENU key is pressed.
<While setting functions, when the FUNC key/DISP MENU key is pressed>
CHARACTER Key: Changes the character type when entering a character. Press
this key while holding down the SHIFT key to switch the character type in reverse
order.
UP/DOWN Key: Switches the setup item or the value.
Press this key while holding down the SHIFT key to switch the setup item
or the value in reverse order.
LEFT/RIGHT Key: Moves the cursor to the right when entering a value
or character. Press this key while holding down the SHIFT key to move
the cursor to the left..
CHARACTER
FUNC
RCD
MENU
DISP
FUNC key
Used when executing manual printout, message printout, etc.
DISP key
Switches the screen in the main display.
MENU key
Hold this key down for 3 seconds to enter Setting mode. Hold this key down for
3 seconds also to exit from Setting mode.
RCD key
Starts/stops recording.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
ESC/?
SHIFT
FUNC
1
FEED
DISP
MENU
ESC Key: Cancels the operation.
When pressed with the SHIFT key, the display of the comment
on the setting turns ON/OFF.
SHIFT Key: Used with the
CHARACTER key.
ENTER Key: Confirms the setup item or value.
ESC/?
SHIFT
1
FEED
CH UP
MENU
CH UP key
Switches the displayed channel.
(when manual switching is specified)
FEED key
Feeds the chart paper.
DISP MENU key
Hold this key down for 3 seconds to switch to the data display
setup screen. Hold this key down for 3 seconds also to exit
from the data display setup screen.
15
16
17
18
19
20
21
22
23
24
CH UP
key,
key, or the
<During normal operation>
IM 04P02B01-02E
Advertisement
Table of Contents
