Installing/Replacing Felt Pens (Pen Model) - YOKOGAWA VigilantPlant mR20000 Operation Manual

Preparing to Record

Installing/Replacing Felt Pens (Pen Model)

30
• Do not press or pinch the felt tip to prevent deformation.
• Do not move the penholder left or right by force to protect the driving
mechanism.
• Make sure to remove the pen cap before installation.
• Use pen caps of the same ink color. If a pen cap of a different ink color is used
on the pen, the remaining ink in the cap may be absorbed through the pen tip,
and the ink may change its color.
1.
Open the door.
If recording is in progress, press the
2.
Open the display and key panel section.
Hold the left and right tabs and pull the display and key panel section toward
you. The section opens upward.
3.
Hold the felt pen cartridge and pull it out from the pen holder.
If the pen (pen holder) is at a position that is not easily accessible, see "When
the Pen (Pen Holder) Is at a Position That Is Not Easily Accessible" below.
4.
Remove the cap from the new felt pen and insert the pen firmly into the pen holder.
5.
Return the display and key panel section to its original position.
When the Pen (Pen Holder) Is at a Position That Is Not Easily Accessible
If the pen (pen holder) is at a position that is not easily accessible, carry out the
procedure below to move it near the center position.
1.
Press the
FUNC
2.
Press the (
Func=Pen exchange
3.
Press the (
CH UP
The pen (pen holder) moves near the center position, and the Pen exchange =
End screen appears.
Note
When the pen moves, a line is drawn on the chart paper.
4.
Replace the pen.
5.
Return the display and key panel section to its original position, and press the
( ) key.
CH UP
The screen returns to the data display screen.
* When the key or
reversed as when the respective key is pressed by itself.
CAUTION
RCD
From the top: pen 1 (red), pen 2 (green),
pen 3 (blue), and pen 4 (violet).
key.
)key several times to display the Pen exchange screen.
DISP
) key.
key is pressed while holding down the SHIFT key, the operation is
key to stop the recording.
IM 04P02B01-02E