Log Set Installation - Vermont Castings Intrepid INDVRBDSB Installation & Operating Manual

Direct vent gas heater
Hide thumbs Also See for Intrepid INDVRBDSB:
Table of Contents

Advertisement

D. Log Set Installation
Before beginning log installation, remove stove front and
glass frame, Figure 3.58.
Note: Remove the safety barrier before you remove the
glass frame. To remove the barrier, simply lift up and pull
out until the tabs are clear of their corresponding slots
on the firebox. Then proceed to remove the glass frame
by following the steps below.
Figure 3.58 - Remove stove front.
DANGER
A barrier designed to reduce the risk of burns from
the hot viewing glass is provided with this
appliance and must be installed.
Before installation, inspect ember bed burner for damage.
Do not use ember bed if damaged or cracked. Small, shallow
surface cracks are acceptable.
Raised Notch
Pin
Figure 3.59 - Ribs for Logs
LG497
SDDVT ember bed
6/07
3434
ST967a
Remove Front
7/07
HOT GLASS WILL
CAUSE BURNS.
DO NOT TOUCH GLASS
UNTIL COOLED.
NEVER ALLOW CHILDREN
TO TOUCH GLASS.
Pilot Assembly
Raised
Notch
Vermont Castings • Intrepid DV-IFT Owner's Manual_R20 • 11/21
1. Remove the logs from their packaging and inspect each
piece for damage. DO NOT INSTALL DAMAGED LOGS.
2. Install the rear log by matching the notch on the bottom
left of the log on the raised notch on back left side of
the ember bed. Cutout on bottom right side is clearance
for pilot assembly, Figure 3.60. Gently push right side
of log back until it contacts the firebox back, slightly pull
forward until seated.
Rear Log
Figure 3.60 - Rear Log
3. Place the left front log on the pin locator on ember bed.
Lg493
Rear log
Position the log over the air inlet hole and on notched out
6/07
portion of ember bed, Figure 3.61.
4. Place front right log on ember bed by mating notch on
bottom of log with raised notch on ember bed. Position
over the air inlet hole and on notched out portion of ember
bed, Figure 3.61.
Left Log
Figure 3.61 - Front Logs
5. Install top log by mating hole on bottom of log with
locating pin on top right side of rear log, Figure 3.62.
Position log so it is angled down toward the area where
the front two logs meet.
LG498
Intrepid left/right logs
7/07
3-90-30007474
Right
Log

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents