Install The Log Set - Vermont Castings Intrepid INDVRCB Homeowner's Installation And Operating Manual

Install the Log Set

Remove the logs from their packaging and inspect each
piece for damage. DO NOT INSTALL
DAMAGED LOGS.
CAUTION: Before installation, inspect
ember bed burner for damage. Do not
use ember bed if damaged or cracked.
NOTE: Small, shallow surface cracks are
acceptable.
1. Install the rear log by matching the
notch on the bottom left of the log on
the raised notch on back left side of
the ember bed. Cutout on bottom right
side is clearance for pilot assembly.
(Fig. 58) Gently push right side of log
back until it contacts thermopile on
pilot assembly.
Figure 59
Pin
Figure 60
Left Log
20012761
Figure 58
Pilot Assembly
Raised Notch
Intrepid® Direct Vent - Rear Vent Gas Heater
Rear Log
LG497
2. Place the left front log on the
pin locator on ember bed.
Position the log over the air
inlet hole and on notched out
Right Log
portion of ember bed. (Fig.
60)
3. Place front right log on ember
bed by mating notch on bottom
of log with raised notch on
ember bed. Position over the
air inlet hole and on notched
out portion of ember bed. (Fig.
60)
LG498
LG493
Raised Notch
29