Install Log Set - Vermont Castings SDDVTBSSB Installation And Operating Instructions Manual

Stardance Direct Vent Gas Heater
®

INSTALL LOG SET

Before beginning log installation, remove stove front and
glass frame. Refer to Figures 40 and 41.
Before installation, inspect ember bed burner for damage.
Do not use ember bed if damaged or cracked. Small, shal-
low surface cracks are acceptable.
1. Remove the logs from their packaging and inspect
each piece for damage. DO NOT INSTALL DAM-
AGED LOGS.
2. Install the rear log by mating the notch on the bottom
of the log with the raised notch on the back left side of
the ember bed. (Figure 42) Ensure the cutout in the
right side of the log is sitting around the pilot assem-
bly and pilot is not obstructed. (Figure 43)
Raised Notch
Pin
Figure 42 Rear Log
LG497
SDDVT ember bed
6/07
Figure 43 Ribs for Logs
Lg493
Rear log
6/07
20306760
Pilot Assembly
Raised
Notch
Rear Log
Pilot
Assembly
ASSEMBLY AND INSTALLATION
3. Install the left log by mating the hole on the bottom
of the log with the pin in the ember bed. (Figure 44)
Position the log over air hole in ember bed.
4. Install the right log by mating the notch on the bottom
of the log with the raised notch on the ember bed.
(Figure 44) Position the log over air hole in ember
bed.
5. Install top log by mating hole on bottom of log with
locating pin on top right side of rear log. (Figure 45)
Position log so it is angled down toward the area
where the front two logs meet.
Left
Log
Figure 44 Front Logs
LG494
left/right logs
Rear Log
6/07
Left
Log
Figure 45 Completed Installation
LG495
SDDVT logs complete
6/07
Right
Log
Top Log
Right
Log
Ember Bed
25