Table of Contents
Advertisement
6.2 Description of the buttons
Table 11: Functions of push buttons
Push button
long press
6.3 LEDs description
6.3.1 POWER (power supply)
When ON (POWER) the pump is powered and the electronic devices are operational.
6.3.2 STATUS
LED
Off
Green steady
Flashing green and orange
Orange steady
Red steady
6.3.3 SPEED (speed bar)
It consists of 10 LEDs, each representing, in percentage steps between 10 and 100%, the speed
range between parameter P27 (minimum speed) and parameter P26 (maximum speed).
Function
Main view (see Par. 6.4.1): decreases the required value for the selected control mode
Parameter menu (see Par. 6.4.2): decreases the displayed parameter index
Parameter view / editing (see Par. 6.4.2): decreases the value of the displayed parameter
Zero pressure auto-calibration (see Par. 6.5, P44): automatic calibration of the pressure
sensor.
Main view (see Par. 6.4.1): increases the required value for the selected control mode
Parameter menu (see Par. 6.4.2): increases the displayed parameter index
Parameter view / editing (see Par. 6.4.2): increases the value of the displayed parameter
Zero pressure auto-calibration (see Par. 6.5, P44): automatic calibration of the pressure
sensor.
Main view (see Par. 6.4.1): START/STOP the pump
Parameter menu (see Par. 6.4.2): switches to parameter view / editing
Parameter view / editing (see Par. 6.4.2): saves the value of the parameter.
Main view (see Par. 6.4.2): switches to parameter selection
Parameters Menu: switches to Main Visualization
and
Main view: alternates between Speed and Head units of measure (see Par. 6.4.1).
and
Main view: alternates between Speed and Head units of measure (see Par. 6.4.1).
Status
Pump unit stopped
Pump unit in operation
Non-locking alarm with the pump unit in operation
Non-locking alarm with the pump unit stopped
Locking error, the pump unit cannot be started
en – Original instructions
27
Advertisement
Table of Contents
