Table of Contents
Advertisement
6.4 Display
6.4.1 Main visualization
Display
OFF
STP
ON
6.4.2 Parameters menu visualization
The parameter menu gives the possibility to:
select all the parameters (see Par. 6.5)
access Parameter View / Editing (see Par. 6.2).
Mode
Description
OFF
Contacts 11 and 12 (see Par. 5.4) are not short-circuited.
Note: It has lower display priority than STOP mode.
STOP
Pump stopped manually.
If the pump is switched on after setting P04 = OFF (see Par. 6.5.1), it is stopped so that the motor
is not in operation, and STP flashes (
To manually stop the pump:
Example A.
CPP/PPP control mode with initial requested value (Head) of 1.00 bar and minimum value 0.5
bar:
4. 2 0
BAR
Example B.
ACT control mode with initial required value (speed) of 200 10xRPM and minimum value 80
10xRPM:
200
10xRPM
ON
Pump on; the motor starts following the selected control mode.
It appears for a few seconds when contacts 11 and 12 (see Par. 5.4) are short circuited and the
pump is not in STOP mode.
To manually set the pump to ON mode:
Example A.
CPP/PPP control mode, reaching a requested value (pressure) of 1.00 bar, starting with a
minimum value of 0.5 bar, after a manual stop:
press
STP
Example B.
ACT control mode that reaches a requested value (speed) of 200 10xRPM, starting with a
minimum value of 80 10xRPM after manual stop:
press
STP
With the pump in operation, it is possible to display the Actual Head and the Actual Speed:
Example A
CPP/PPP control mode with Actual Head 1.00 bar and corresponding Actual Speed 352
10xRPM:
4. 2 0
BAR
4. 2 0
BAR
.
Example B
ACT control mode with Actual Speed 200 10xRPM and corresponding Actual Head of 2.37 bar:
200
10xRPM
10xRPM
.
STP
STP
).
STP
press
once.
press
STP
once.
once after a few seconds...
ON
once, and after a few seconds...
ON
352
10XRPM
+
2. 3 7
BAR
+
en – Original instructions
4. 2 0
BAR
200
10XRPM
after 10 seconds or
after 10 seconds or
+
200
+
29
Advertisement
Table of Contents
