Table of Contents
Advertisement
6.5.1 Status Parameters
No.
P01
P05
P06
P07
P08
P09
P10
P11
P12
P13
P14
P15
P16
P17
Parameter
Required value
Operating time months
Operating time hours
Motor Time Months
Motor time hours
1st error
2nd error
3rd error
4th error
Power Module
Temperature
Inverter Current
Inverter Voltage
Motor Speed
Software version
Unit of
Description
measurement
bar/psi/ rpmx10
This parameter shows the SOURCE and the VALUE of the
active required value.
Visualization cycles between SOURCE and VALUE occur every
3 seconds.
SOURCES:
SP (SP): internal required value Setpoint related to the
control mode selected.
VL (UL): external required value speed Setpoint related
to 0-10V input.
VALUE can represent a Speed or a Head, depending on the
selected control mode:
in case of Head, the unit of measure is defined by parameter
P41.
Total months of connection to the electric mains, to add to
P06.
h
Total hours of connection to the electric mains, to add to P05.
This parameter shows the total operating time months, to be
added to P08.
h
This parameter shows the total operating time hours, to be
added to P07.
This parameter stores the last error occurred in chronological
order.
The information displayed switches through the values:
(Exx): xx indicates the error code
(Hyy): yy is the value of hours referred to P05-P06 when
the error Exx happened
(Dww): ww is the value of days referred to P05-P06 when
the error Exx happened
(Uzz): zz is the value of weeks referred to P05-P06 when
the error Exx happened
Example of visualisation:
E04
Saves the penultimate error in chronological occurred.
Other characteristics: like P09.
Saves the third from the last error in chronological occurred.
Other characteristics: like P09.
Saves the fourth from the last error in chronological occurred.
Other characteristics: like P09.
°C
Temperature of the power module.
A
This parameter shows the actual current supplied by the
frequency converter.
V
This parameter shows the actual estimated input voltage of
the frequency converter.
rpmx10
This parameter shows the actual motor rotational speed.
This parameter shows the Control Board software version.
en – Original instructions
K10
d03
U15
31
Advertisement
Table of Contents
