Table of Contents
Advertisement
en – Original instructions
Parameter
Power on
Password timeout
Parameters Menu
Parameters Editing/Visualization
6.4.3 Alarms and errors visualization
Parameter
Alarm
Error
6.5 Software parameters
Parameters are marked differently in the manual depending on their type:
Mark
No mark
30
Description
If after switching ON, parameter Menu View is accessed with P23 = ON, P20
flashes:
Enter the password to display and change the parameters.
If with P23 = ON no button is pressed for over 10 minutes from the last
parameter Menu View, both the view and the editing of the parameters are
disabled.
Enter the password again to display and change the parameters.
With P23 = OFF, or after entering the password (P20), it is possible to both
display and edit the parameters. When accessing the Parameter Menu, the
display shows:
P01
P02
...
P69
The flashing parameter, indicating the selection possibility.
The value of a parameter may be changed using the buttons, or the Modbus
and BACnet communication protocols.
When returning to the Parameter Menu, the displayed parameter index is
increased automatically. For further information see Par. 6.5.
Example A (P20) from 000 to 066:
Example 2 (P26) from 360 to 300:
Description
In case of alarm, the corresponding code appears on the display in alternation to the Main View.
For example:
A01
3. 5 6
(ex. BAR)
A02
285
(ex. 10xRPM)
...
For further information see Par. 6.7.
In case of error, the corresponding identification code appears on the display.
For example:
E01
E02
...
For further information see Par. 6.7.
Parameter type
Applicable to all units
Read only
P20
P20
.
P01
P02
P69
P20
P20
000
066
sets the desired value
P21
P21
P26
P26
360
sets the desired value
300
P26
P26
.
... until ...
000
... until...
360
066
300
Advertisement
Table of Contents
