2: Installing A Security Tamper Switch; 3: Receiving Unit; 4: Programming - Notifier NFS2-640/E Installation Manual

Fire/Security Applications
For bypass of security zones, use the DISABLE routine (covered in the Status Change section of
the NFS2-640/E Operations Manual) for Security type devices.
WARNING:
!
Damage can result from incorrect wiring connections.
4.6.2 Installing a Security Tamper Switch
To wire the cabinet with a Security Tamper Switch kit model STS-1, refer to Figure 4.5:
1. Install the STS-1 Tamper Switch onto the side of the backbox opposite the door hinge, pushing
the switch through the opening until it snaps into place.
2. Install the magnet on the same side of the cabinet door as the lock. Push the magnet through
the opening in the door until it snaps into place.
3. Connect the STS-1 connector to J5 (Security Tamper) on the Control Panel. (As shown in
Figure 4.5, J5 is located on the circuit board, underneath the edge of KDM-R2.)
Figure 4.5 Installing the STS-1 Security Tamper Switch
4.6.3 Receiving Unit
For applications requiring transmission of security alarm information to a central receiving unit, the
control panel may be connected via the UDACT or UDACT-2 to a compatible receiving unit (see
the UDACT Manual or UDACT-2 Manual). For information on configuring the Receiving unit for
Combination Fire/Security applications, refer to the documentation for that control panel.
4.6.4 Programming
The control panel can communicate with any number of security devices. To do so, program the
points as follows:
1. Select the address of the module(s) to be used for security.
2. Select the Type Code
NOTE: For detailed instruction on programming Type Codes, refer to the NFS2-640/E
Programming Manual.
NFS2-640/E Installation Manual — P/N 52741:P2 7/10/14
LED1 J6 J5
.
SECURITY
Applications
Connect to
J5 "Security Tamper"
STS-1 mounting location
(side opposite of door hinges)
53