3: Installing And Configuring A Keltron Printer - Notifier NFS2-640/E Installation Manual

Installing Remote Printers and/or CRT
Option
Font
LPI
ESC Character
Bidirectional Copy
CG-TAB
Country
Auto CR
Color Option
Formlen
Lines
Standard
3.13.3 Installing and Configuring a Keltron Printer
Connect the remote printer to the Control Panel as follows:
1. Connect the three (3) open leads of the custom cable to the TB12 terminal block on the control
panel as shown in Figure 3.26.
2. Connect DC power from TB10 terminal block on the control panel as shown in Figure 3.26.
3. Plug the DB-25 connector end of the custom cable into the EIA-232 port of the Keltron printer.
Tighten securely.
Keltron printer
24 VDC connections
(14 AWG, 2.08 mm
Control
Panel
Setting up the Keltron Printer
Set up a Keltron printer as follows:
1. The printer communicates using the following protocol:
• Baud Rate: 9600 • Parity: Even • Data bits: 7
2. Set the printer DIP switches SP1 and SP2 according to settings in Table 3.7.
NFS2-640/E Installation Manual — P/N 52741:P2 7/10/14
Setting Option
HS Draft CPI
6 LPI Skip
ESC Emulate
ON I/O
Graphic
Serial
E-US ASCII
OFF
Not Installed
Character Set
6LPI=60
Sl.Zero
Exec 10.5
Auto LF
PAPER
Table 3.6 PRN Setup Options
Keltron printer
DB-25 connector
2
) (female socket shown)
Figure 3.26 Keltron Printer Connections
Setting
10 CPI
0.5
Epson FX-850
Buffer 40K
Baud 9600, 4800, or 2400
Format 7 Bit, Even, 1 Stop
Protocol XON/XOFF
Standard
On
Off
BIN 1 12/72"
BIN 2 12/72"
SINGLE 12/72"
PUSH TRA 12/72"
PULL TRA 12/72"
PAP ROLL 12/72"
Control
Panel
Installation
Terminate one end of
shield at backbox
43