Option 080, Frequency Offset Measurements; Option 082, Scalar Calibrated Converter Measurements; Option 083, Vector And Scalar Calibrated Frequency Converter Measurements; Option 1Cm, Rack Mount Kit For Instruments Without Handles - Agilent Technologies N5242A Service Manual

PNA Series Microwave Network Analyzers
N5241A/42A
high-accuracy noise figure measurement capability to your 2-port or 4-port analyzer.

Option 080, Frequency Offset Measurements

This option can be added to any other option combination.
This option enables the additional firmware necessary to make frequency offset
measurements by enabling the analyzer to set the source frequency independently from
where the receivers are tuned. This ability is important for measuring amplifiers, mixers,
and frequency converters.

Option 082, Scalar Calibrated Converter Measurements

This option can be added to any option combination that includes Option 080 but does not
include Option 083.
This option enables the additional firmware necessary to make scalar calibrated converter
measurements by providing an intuitive and easy-to-use user interface for setting up
mixer and converter measurements.

Option 083, Vector and Scalar Calibrated Frequency Converter Measurements

This option can be added to any option combination that includes Option 080 but does not
include Option 082.
This option enables the additional firmware necessary to make both vector and scalar
calibrated converter measurements by providing an intuitive and easy-to-use user interface
for setting up mixer and converter measurements. This option includes the
Scalar-Calibrated Converter Measurement (SMC) and the Vector-Mixer Calibration (VMC).

Option 1CM, Rack Mount Kit for Instruments without Handles

Option 1CM provides a rack mount kit that contains a pair of flanges, rack mount rails,
and the necessary hardware to mount the analyzer (not equipped with handles) in an
equipment rack with 482.6 mm (19 inches) horizontal spacing.
Additional kits may be ordered from Agilent. Refer to
on page 6-83 for the part numbers.

Option 1CP, Rack Mount Flange Kit for Instruments with Handles

Option 1CP provides a rack mount kit that contains a pair of flanges (cut to adapt to
handles), rack mount rails, and the necessary hardware to mount the analyzer in an
equipment rack with 482.6 mm (19 inches) horizontal spacing.
Additional kits may be ordered from Agilent. Refer to
on page 6-83 for the part numbers.

Option 200, Standard 2-Port Configuration

This is a 2-port network analyzer with an upper frequency limit of either 13.5 GHz
(N5241A) or 26.5 GHz (N5242A). This is the standard 2-port analyzer and contains:
• one internal source
Service Guide N5242-90001
General Product Information
Analyzer Options Available
"Rack Mount Kits and Handle Kits"
"Rack Mount Kits and Handle Kits"
2-5