Fuel Tank (Bs Models) - Wacker Neuson BS 50 Repair Manual

Engine and Upper Machine Components
4.13

Fuel Tank (BS Models)

See Graphic: wc_gr001312rm
4.13.1 Remove the silencing cover.
4.13.2 Close the fuel valve (a).
4.13.3 Disconnect the fuel line (b) from the fuel tank. Disconnect the vent line
4.13.4 Drain the fuel into a suitable container.
4.13.5 Remove the four socket head cap screws that hold the fuel tank to the
4.13.6 Unscrew the filter (d) from the fuel tank.
4.13.7 Clean the fuel filter. Replace the fuel filter if the mesh element is torn
4.13.8 Clean the inside of the fuel tank to remove any sediment.
(c) where used.
Note: In the interests of environmental protection, place a plastic sheet
and a container under the machine to collect any liquid which drains
off. Dispose of this liquid in accordance with environmental protection
legislation.
guide handle. When reinstalling the fuel tank, apply Loctite 243 and
torque the screws to 9.4 Nm (6.9 ft. lbs.).
Note: It is not necessary to separate the fuel valve from the fuel filter
unless replacing the parts. To separate, pull and twist the fuel valve
from the fuel filter.
or punctured.
52
Repair
wc_tx001546gb.fm