Wacker Neuson BS 50 Repair Manual page 29

Repair
Installation
4.2.1
4.2.2
4.2.3
4.2.4
Result
wc_tx001546gb.fm
Engine and Upper Machine Components
Perform the procedure below to install the throttle control.
Connect the throttle control
. Adjust the nut on the throttle control lever so that the
hardware
(b)
lever moves freely but still holds its position while the rammer is
operating. The recommended torque value is 2.9 Nm (2.1 ft.lbs.).
Connect the throttle cable to the machine at point
Connect the throttle cable to the carburetor. To do so:
a. Place the throttle control
mm (0.030 in.) feeler gauge between the throttle control and the
machine.
b. Rotate the throttle lever
adapter .
(f)
c. Thread the throttle cable
through the swivel
swivel screw.
d. Release the throttle lever.
Install the carburetor guard
The replacement procedure is now complete.
to the machine with bolt
(c)
in the full throttle position with a 0.76
(c)
so that it is tight against the carburetor
(x)
through the carburetor adapter and
(e)
. Pull the throttle cable taught, then tighten the
(d)
. Torque the screws to 23 Nm (16 ft.lbs.)
(a)
29
and
(h)
.
(g)