Periodic Maintenance Schedule (Ds 720) - Wacker Neuson BS 50 Repair Manual

Rammer Repair
3.6

Periodic Maintenance Schedule (DS 720)

Check fuel level.
Check engine oil level.
Check rammer oil level in
sightglass.
Check fuel line, cap and
fittings for cracks or leaks.
Check bellows for damage
and fit.
Tighten ramming shoe
hardware.
Check external hardware.
Clean engine cooling fins.
Change engine oil.*
Clean engine oil filter.*
Clean recoil starter.
Change ramming system
oil.*
Inspect crane lifting cable for
wear, damage, or abuse.
Check and adjust valve
clearance.**
Replace engine oil filter.
Check fuel filter, clean or
replace.
* Perform initially after first 50 hours of operation.
** Perform initially after first 25 hours of operation.
Note: If engine performance is poor, check, clean, and replace air filter elements as needed.
wc_tx001545gb.fm
The table below lists basic machine maintenance. Tasks designated
with check marks may be performed by the operator. Tasks
designated with square bullet points require special training and
equipment.
After
Daily
first
before
5
starting
hours
Maintenance Schedules
Every Every
week month
or or
25 hours 100 hours
25
Every 3 Every 5
months or months or
300 hours 500 hours