Inserting And Removing An Sd Card - Eaton XV-102 Operating Instructions Manual

6.4

Inserting and removing an SD card

Fig. 36 SD slot (A)
CAUTION
Data loss
During a write operation, the SD card may lose data or may be destroyed if it is re-
moved or if there is a power failure.
Only insert the SD card when the device is in a de-energized state.
Avoid write operations to SD cards. Reasons:
- The number of write cycles possible on SD cards is limited.
- A power failure during write operations will most likely lead to loss of data.
Only remove the SD card when the device is in a de-energized state.
Before switching off, ensure that no software write operations to the SD card are
in progress.
Do not apply any force (SD cards are protected against reverse insertion).
Inserting the SD card
1 Push the SD card into the SD slot (A) until it snaps into position.
Removing the SD card
1 Push the SD card in the SD slot (A) all the way in.
This releases the lock mechanism and the SD card comes out of the SD slot a little.
2 Remove the SD card from the SD slot.
XV-102 Micro Panel MN04802004Z-EN—February 2013 www.eaton.com
www.comoso.com
6.4 Inserting and removing an SD card
6 Operation
55